Layout
1. Supplying Power
-
DC 5V Input
This port is the input port for supplying power. The input voltage is DC 5V(±0.5V) and the specification is as follows:
2. Ethernet
Ethernet port supports 10/100Mbps Ethernet. This port is an RJ45 connector and it is mapped to NET0 for programming.
3. RTD Port
This port is interfaced with a 3-pole terminal block. You can connect a 3-wire Pt100 temperature sensor to this port.
| Lable | Description |
|---|---|
| A | Pt100 sensor input terminal A (red) |
| B | Pt100 sensor input terminal B X 2 (white) |
4. 7-Segment LED
This 3-digit 7-segment LED is for displaying measured temperature.
5. LED
This product has 4 system LEDs.
| Lable | Color | Description |
|---|---|---|
| PWR | Red | System LED - power status |
| STS | Yellow | System LED - system status |
| RJ45_G | Green | System LED - network link status |
| RJ45_Y | Yellow | System LED - system status |
6. Function Button
The function button, which is inside the hole of the side panel, is used to operate this product as a button setup mode.
7. USB Device Port for connection with PC
The USB device port is to connect with PC. You can access to P5H-156 via development tool by connecting USB cable to this port.