Settings

All parameters including an IP address can be configured through PHPoC Debugger.

Setting Steps

  1. Connect PHPoC product to PC via USB.
  2. Run PHPoC Debugger.
  3. Click the connect button(manage_config_01) after choosing the right COM port.
  4. After then, click configuration (manage_config_02) button.
  5. Configure parameters.
  6. Click the [Save] button to save the configuration.

※ Note: You can also set PHPoC products via Connection via network.

Setting Parameters

Tab Category Parameter
IP Address IPv4 IP address type - Obtain an IP automatically
IP address type - Use static IP address
IP Address
Subnet mask
Gateway IP address
IP address type - Obtain DNS server address automatically
DNS server IP address
IPv6 IPv6 - Enable / Disable IPv6
IP address type - Obtain an IP automatically
IP address type - Use static IP address
EUI - MAC Address / Random
IPv6 address and Prefix
Gateway IPv6 address
Obtain DNS server address automatically
DNS server address
Wireless LAN Basic Settings WLAN - Enable / Disable WLAN
WLAN Topology - Infrastructure / Soft AP
Search AP / Search channel
Channel
SSID
Internal Antenna / External Antenna
Advanced Settings
Security Shared Key
802.1X: EAP-TTLS / PEAP
Advanced Time Set RTC time
Password Password (ID: admin, pdbuser, setup)
Certification Type - Host / Client / Root CA
Write certificate
Write signed certificate from certification authorities
Read the certificate form a product
Delete the certificate form a product
Network Local LAN name server
Service discovery
Network debugger
Secure network debugger
Remote debugger